Table of Contents
Advertisement
Chapter 3 Setting Up to Watch Television
For 'Preparing Your Plasma TV for Wall Mounting', see page 6.
3.1 Basic Plasma TV Start Up
1. Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the Plasma TV, and then
plug the power cord into an AC wall socket.
2. Connect Audio and Video Cables to the Plasma TV
(see pages 16-29 for detailed steps)
3. Turning Power On
Once all the components are connected, press the Power ON button on the side of the Plasma
TV, or press the Power ON (Red) button on the remote control.
4. Select Input Source
Select the Input Source for the Plasma TV by pressing the INPUT button
on the side of the TV or using the Input button on the remote control.
Pressing this button will cycle you through the following options: AV1, AV2,
AV3 (Video), Component 1, Component 2, HDMI, RGB, TV and DTV.
5. Using TV with an Antenna or Cable
If connecting to an antenna or cable source for the TV input, you will need
to select the appropriate source within the On-Screen Display (OSD)
menu and Auto Scan for the available TV channels.
Please follow the instructions below:
a. Select TV input by pressing the INPUT button on the side of the Plasma TV or using the
INPUT button on the remote control, or directly by pressing the TV button on the remote
control.
b. Press the MENU button on the remote control to show the OSD menu.
c. Press the
menu.
Note: If you do not see this option within the OSD, you might have selected the wrong input in the
previous steps and you will need to repeat step 4 (above) to select the correct input source.
Version 1/18/2006
button on the remote control twice to highlight the TV TUNER SET UP
30
www.VIZIOCE.com
VIZIO P42 HDTV User Manual
Advertisement
Table of Contents
