Echo GT-1100 Operator's Manual page 9

OPERATION
5. Turn choke lever to RUN (open) position.
6. Start engine.
7. Release throttle trigger and allow engine to warm
up.
8. Squeeze throttle trigger gradually.
WARM ENGINE STARTING
1. Turn ignition switch to START/RUN position.
2. Place the choke lever in the RUN (open) position.
3. Pull starter handle.
NOTE: If engine does not start after 4 pulls, use cold
start procedure.
STOPPING ENGINE
1. Release throttle trigger and allow engine to idle.
2. Turn ignition switch to STOP.
,/|\ CAUTION: If engine does not stop, close choke
lever to stop engine. Check and repair stop switch
before starting engine again.
NOTE: The ignition switch on the G.T. 1100 is located
next to the carburetor.
8