Warning Message - Vizio L6 User Manual

Warning message

When the main input source is DVI and no Multi screen function is active, the LCD TV will go into the
power saving mode if there is no signal input. The message shown in Figure31 will be displayed for
approximately five (5) seconds and then the LCD TV will power off to the power save mode.
1. The main input is the DVI mode.
2. The multi screen function is disabled, (PIP or POP is not active.)
3. No sync input, (no signal), is on the DVI input
4. The LCD TV goes into the power save mode in approximately five (5) seconds.
When the main screen input source is DVI mode and timing or resolution exceed the specification of
the display, an Out Of Range message will be shown on the screen, as in Figure 32.
1. The main input source is DVI mode.
2. The timing of the DVI signal is more than 69kHz or less than 30kHz for the horizontal frequency,
and/or greater than 85Hz or less than 50Hz for the vertical frequency.
3. The resolution of the DVI signal is greater than 1024 x 768.
When the Reset All Settings function is chosen in the Special Features sub menu, this message will be
displayed in the center of the screen, (Figure 33). This action resets the user settings to the factory
default value.
Figure 31 Power save message
Figure 32 Out of range message
Figure 33 Reset all settings message
35
VINC.COM