Advertisement
The appliance has an anti calc indicator located on the control panel. When this indicator is flashing it means that
the anti calc cartridge is no longer efficient and must be replaced by a new one.
To replace your anti calc cartridge :
- Never replace the anti calc cartridge during use.
- Switch off and unplug your appliance.
- Remove the water tank
- Pull the used anti calc cartridge out of its compartment.
- Be careful, some water drops may drip from of the anti calc cartridge when you remove it from its compartment.
This is normal and the water is harmless.
- Take the new anti calc cartridge out of its bag.
- Place the new anti calc cartridge in the compartment and press it down until it locks.
- Put the anti-calc cartridge back in the water tank
- Plug in and switch on your appliance. The max indicator located on the control panel flashes while the iron heats
up. When the max indicator light stops flashing (after 2 minutes approximately), the appliance is ready for use.
- Press the anti calc reset button on the control panel.
- You might have to press the steam control button for a few minutes to start the steam again as your appliance needs
to re-activate its water circuit when the temperature dial is in the Max position.
This operation is essential to maintain the working life of your appliance.
Using the appliance without changing the cartridge can damage the appliance and stop its steaming
performance. Press on the anti calc button only if you have changed the cartridge.
To ensure the efficiency of the cartridge, please remove it from its plastic bag just before use. The
international guarantee will not cover any damages which occur as a result of using the appliance without
changing the cartridge.
Self-cleaning
1. Switch off and unplug the appliance
2. Remove the water tank from it's housing, refill the tank up to the max mark, and push it back into it's
housing until you hear a click
3. Plug in the appliance
4. Set the temperature control dial to the max position
5. Switch on the appliance; the anti-calc light should be off and the ON button should be flashing.
6. Once the ON button stops flashing and becomes fixed, press and hold the ANTI CALC button for 8
seconds.
7. When the anti-calc light starts flashing, the self-cleaning program will start.
7a. Handle the iron over the sink, keep it in an horizontal position. Do not proceed to the self-cleaning
if the iron is on the iron heel or on the iron rest
7b. The iron will heat up and may take up to 1min20seconds to do so.
7c. Once the iron has heated up, the self-cleaning will automatically begin. Water, steam and calc
particles will come out of the sole plate (this takes approximately 45 seconds)
7d. The iron will then heat up again for about 30 seconds to dry the soleplate
7e. Once the self-cleaning has finished, the appliance will automatically switch off.
8. If cleaning the soleplate is necessary, unplug the appliance and ensure that the iron cools down
completely
9. Once the iron has cooled down completely, clean the sole plate with a damp cloth/sponge
10. Your appliance is now ready to use
Cleaning your appliance
Before cleaning, ensure your appliance is unplugged and that the soleplate and the iron have cooled down for
least 1 hour.
• Do not use detergent or descaling products for cleaning the soleplate base-unit.
• Never hold the iron or the base unit under the tap.
• Regularly clean the soleplate with a damp, non-metallic dish cloth.
• Clean the plastic parts of the appliance occasionally with a soft cloth.
Storing your appliance
• Warning: do not touch the soleplate while still hot.
• Store the water connection cord in its compartment.
19
Advertisement
