Vivotek FD7141 Quick Installation Manual page 8

1. Attach the supplied ceiling hole template sticker to the ceiling.
2. Open a hole along the inner circle of the sticker.
3. Using the 3 circles on the sticker, drill 3 pilot holes into the ceiling. Then hammer the three supplied
plastic anchors into the holes.
4. Mount the Network Camera to the ceiling and feed the cables through.
5. Using the three holes on the side of the camera base, insert the three supplied screws into the cor-
responding holes and secure them with a screwdriver.
Drill hole
Ceiling Hole Template Sticker
1. If you have external devices such as sensors and alarms, make the
connection from the general I/O terminal block.
N . C . : No Connector
N . C . : No Connector
N . C . : No Connector
AC24V: Power in AC 24V
AC24V: Power in AC 24V
G N D : Ground
D I
D O
+ 1 2 V : Power, 12V DC
: Digital Input
: Digital Output
2. Use the supplied RJ45 female/female coupler
to connect the Network Camera to a switch.
Use a Category 5 Cross Cable when Network
Camera is directly connected to PC.
3. Connect the power cable from the Network
Camera to a power outlet.
EN - 7