Vivotek FD7141 Quick Installation Manual page 7

1. Attach the supplied alignment sticker to the wall.
2. Using the 10 circles on the sticker, drill 2 pilot holes symmetrically on each side into the wall. Then
hammer the four supplied plastic anchors into the holes.
3. Using the four holes on the bottom base, insert the four supplied screws to corresponding holes and
secure the bottom base with a screwdriver.
4. Feed the cables through hole A or B. If you want to use hole B, remove the rubber stopper with a
screwdriver.
5. Secure the camera base to the bottom base with three supplied screws.
B
EN - 6
A