Table of Contents
Advertisement
OPTIONS
Options are used to activate or de-activate various special functions. Thus, it might be necessary to
add several options, in which case they are added one by one.
Option programming is only required during the initial installation, and it is carried out with a Bang
& Olufsen remote only.
When power is applied to OneRemote Radio PL7 and it is Booting, the LED in the upper left corner
of the display, will flash for 8 seconds. Within these 8 seconds an Option code-sequence may be
initiated. 5 Seconds are then available to enter each digit of the Option code, so there is no rush.
If the PL7 is already powered on, it can be soft-booted with the Bang & Olufsen remote control.
At any time a soft-boot can be made by pressing
The tables below show the available Options for OneRemote Radio PL7.
LED DISABLE OPTION
On the upper left side of front OneRemote PL7, a small Blue LED indicates when it is powered on.
Good to have for most people, to see when the PL7 is controllable.
Some find this light annoying and do not need it. Thus, we have made the Disable-LED Option.
Options may be programmed only at booting of the PL7, while the blue lamp is flashing.
DISABLE LED
Disable the LED so it will not
light up when the Radio PL7 is
powered on.
Enable the LED so it will light
up when the Radio PL7 is
powered on.
*1 If the LED is flashing, enter the code.
Soft Boot PL7, make the LED flash press
*2 If the Bang & Olufsen remote control used does not have a
www.oneremote.dk
!u
Factory
Option
L950w
*1 *2
L951w
x
*1 *2
e u
,
, see note below the tables.
!u
or x
L
button, instead use
u
.
g
.
10
Advertisement
Table of Contents
