Table of Contents
Advertisement
ae
%
AC voltage selection
These
units operates
on
110-120
volts or 220-240
volts
AC. The AC voltage selector switch of the amplifier is set to
the voltage that prevails in the area to which the units was
shipped. Before connecting the power cord to your AC outlet,
make sure that the setting position of this switch matches
your line voltage. If not, it must be set to your voltage in ac-
cordance with the following direction.
Note:
Our warranty
does
not cover
damage
caused
by excessive
line
voltage due to improper setting of the AC voltage selector switch.
AC110-120V\<
»AC220-240V~
AC110-120V~<
» AC220-240V~
This shows switch
lever is locked in
220-240V~position.
This shows switch
lever is locked in
110-120V~position.
Move
switch
fever to match
your
line
voltage with a small screw driver or other
pointed tool.
AC voltage selector switch
"Note to CATV system installer:
Before operation
Safety precautions
Never remove the case. If the internal parts are touched
accidentally, a serious electric shock might occur.
Never touch internal
parts.
If a metal object, such as a hair pin or a needle, comes
into contact with the power socket on the rear panel, a
dangerous electric shock may result. For families with
children,
never
permit
children
to
put
anything,
especially metal, inside this unit.
22 \KR-V125R/KR-V75R (U)
;
Y
Do not connect other audio equipment with a power
consumption larger than that specified to the AC outlet
on the rear panel. Never connect other electrical ap-
pliances, such as an iron or toaster.
Never connect other
electrical appliances.
Touching the power
plug when
your hands are wet
may result in a serious electric shock.
aS
S
JOU
Never pull, bend or extend the power cord. This could
damage the power cord, resulting in a broken cord or
short-circuit.
Never touch with wet
hands.
a7
ov
Never pull or stretch
the cord.
In case of abnormal smell
If an abnormal smell or smoke is detected, immediately
turn the power OFF and pull out the power cord. Con-
tact your dealer or nearest service station.
Cleaning
Do not use volatile solvents such as alcohol, paint thin-
ner, gasoline, benzine, etc. to clean the cabinet. Use a
silicone cloth or a clean dry cloth.
Thinner
Benzine
Silicone cloth
Installation precautions
a)
Avoid locations subject to direct sunlight.
b)
Avoid high or low temperature extremes.
c)
Keep the unit away from heat radiating sources.
d)
Choose a location that is relatively free of vibration
or excessive dust.
e)
Make sure power is off before making any system
connections.
Advertisement
Table of Contents
