Measuring A Split Time; Timing The First And Second Place Finishers; Timer; Setting A Start Time - Casio G-Shock GW-9500-1A4 Installation Instruction

Measuring a Split Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
A
Start
C
Split
C
Split release
A
Stop
Hours
Minutes, seconds, 1/10 seconds
3.
Press (C) to reset the measurement time
to all zeros.
Watch Operation Guide 3553
Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
* Displays the time of the first finisher.
3.
Press (C) to display the time of the second
place finisher.
4.
Press (C) to reset the measurement time
to all zeros.
A
Start
C
1st Finisher*
A
2nd Finisher*
Hours
Minutes, seconds, 1/10 seconds

Timer

The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper will not sound if battery power
●
is low.

Setting a Start Time

The countdown start time can be set in 1-
minute units up to 24 hours.
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (E) for at least two seconds.
Release the button when the hour setting
starts to flash.
Hours
3.
Use (A) and (C) to change the timer hours
setting.
Holding down (A) or (C) scrolls through
●
settings at high speed.
4.
Press (D).
This causes the minutes digits to flash.
Minutes
32