Selectinga Component - Sony STR-DH500 Operating Instructions Manual

5
6
7
Press e/t repeatedly to select
"T. TONE Y".
The test tone is output from each speaker
in sequence as follows:
Front left -+ Center -+ Front right -+
Surround right -+ Surround left -+
Subwoofer
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see "Adjusting the level
(LEVEL menu)" (page 32).
Tips
• To at!just the level of all speakers at the same
time, press MASTER VOL +_. Youcan also
use MASTER VOLUME on the receiver.
• The at{justed value is shown on the display
during a_[justment.
Repeat steps 1 to 5 to select
"T. TONE N".
You can also press any input buttons.
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.
Note
The test tone does not work when ANALOG
DIRECT is selected.
Selectinga component
_BI_NJ_Y OR_ _gIRR
Input
................. buttons
AMP
MENU
,,,,,,,,,,,,,,, MUTING
MASTER
_VOL+_
Press the input button to select
a component.
You can also use INPUT SELECTOR on
the receiver.
The selected input appears on the display.
continued
25us