Connect The Audio Wiring; Connect Auxiliary Devices; Figure 3.10 Crown Bus Wiring "Loop" From Output To Input - Crown IQSMX-6 Reference Manual

3.3 Connect the Audio Wiring (Step 3)
IQ mixer/multiplexers have 6 mic/line inputs and 2
stack inputs (Input 6 of the IQ–AMB-5 is dedicated for
ambient sensing). Two audio channels feed two main
and two auxiliary bus outputs. Three-terminal remov-
able barrier block connectors are provided for the mic/
line inputs and main and bus outputs. RCA-type
phono jacks are provided for the stack inputs. See
Section 5.1 for information on the operation of the
mixer/multiplexer inputs and outputs.
Figure 3.10 Crown Bus Wiring "Loop"from Output to Input of Each IQ Component
Page 14
3.4 Connect Auxiliary Devices (Step 4)
Connect any external circuits you plan to use to
control the AUX input and/or monitor the AUX output
of the mixer/multiplexer. See section 5.2 for
information on the operation of the AUX input and
output and for examples of wiring circuits to the AUX
connector.
AUDIO
IN
AMB-5 / SMX-6 IQ Mixer/Multiplexer
Important: Provide adequate
cooling if the unit will be used in a
hot environment. It is good prac-
tice to allow one empty rack
space (1.75 inches or 4.4 centi-
meters) between each unit if
more than four units will be
stacked in a cabinet. Each empty
rack space should be sealed with
a blank rack panel to facilitate
proper air flow inside the cabinet.
IQ–AMB-5 / IQ–SMX-6 Reference Manual