Touch Plate; Editknob - Roland GR-700 Owner's Manual

~ | c. Made Switch
With this switch set to the II or III
position, both direct guitar and synthe-
sizer sounds are available. At the I posi-
tion, only direct guitar sound is obtained
and the Balance knob (3) does not work.
In the II mode, fairly week picking is
sufficient to sound the synthesizer, but
in the III mode; slightly hard picking
is required,
11
J
*{f using the Guiter Controller G-303 or
G-808, select the position as follows.
vco >]
vco+DIST => i
DIST =I
[ d. Vibrato knob and e. Touch Plate
By using these knobs, vibrato effect can
be obtained. Slightly raise the Vibrato
Knob (d) and touch the Touch Plate A
while holding the string(s) down. To stop
vibrato, touch the Touch Plate B and
immidiately release. If the sound has
initially taken on the vibrator effect, stop
it with the Touch Plate B, then do the
above operations. The rate, delay time
and depth of the vibrato effect work at
its set level in writing. Therefore, it is
necessary to have set these to appropriate
levels even when you are writing a patch
without vibrato effect (the LFO Modura-
tion Switch is set to off).
*if the Vibrator Knob (d) is set to zero,
no vibrato effect is obtained, therefore
you are not annoyed by unexpected
Vibrato effect caused by touching
the Touch Plate accidentally.
f, Cutoff Frequency Knob and g. Edit Knob (Resonance in other G series)
Either of these knob works exclusively in
Edit mode. The Cutoff Frequency Knob
(f) is provided specifically for VCF Cut-
off Frequency controlling. Edit (Reso-
nance Knob) (g) is used to control para-
meters other than that.
* Refer to (4) Edit" on the next page for
the details.