Operation - Husqvarna 230iB Operator's Manual

To attach the scraper tool
The scraper tool can be used to loosen leaves
and other unwanted material for easier cleaning.
• Attach the scraper tool to the blower nozzle
until the tab (A) goes into the hole (B). Make
sure that the scraper tool and the tube are
locked together. (Fig. 23)
To install the battery charger on the
wall
CAUTION:
screwdriver to install the battery
Introduction
WARNING:
the safety chapter before you use the
product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks.
Use a brush and clean off grass and leaves
from the product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make
sure that they are tight.
To connect the battery charger
WARNING:
charger in ambient temperatures
between 41°F (5°C) and 104°F (40°C).
1. Connect the battery charger to the voltage
and frequency that is specified on the rating
plate.
2. Put the plug in a grounded power outlet. The
LED on the battery charger flashes red 1 time
and green 1 time.
To charge the battery
CAUTION:
battery, the battery charger and the
terminals on the battery are clean and
1516 - 008 - 29.11.2023
Do not use an electric

Operation

Read and understand
Only use the battery
Make sure that the
charger to the wall. An electric
screwdriver can cause damage to the
battery charger.
1. Install the battery charger on the wall with
the 2 screws (A). Use wall plugs (B) if it is
necessary. (Fig. 24)
2. Install the 2 screw hole plugs (C).
3. Connect the power cord (D) to the battery
charger and a mains socket.
dry. Do not put the battery in the
battery charger if it is dirty or wet.
1. Connect the battery charger to a power outlet.
The charging LED flashes red 1 time and
green 1 time.
CAUTION:
battery charger to a power outlet
with the voltage and frequency
specified on the rating plate.
2. Connect the battery to the battery charger.
The charging LED comes on.
3. Remove the battery from the battery charger
when it is fully charged. Push the battery
indicator button for battery status. When all
the LED indicators come on, the battery is
fully charged.
4. Pull the power plug to disconnect the battery
charger from the power outlet. Do not pull the
power cord.
To connect the battery to the product
WARNING:
original batteries in the product.
1. Make sure that the battery is fully charged.
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it
is not installed correctly. (Fig. 25)
Only connect the
Only use Husqvarna
15