CONNECTION & OPERATION
Keyboard
To Input Jack
To Effect Remote Jack
Foot Switch
(FS-1: Option)
Olele!-)
Tape Recorder
jams)
DIRECT MUTE
ON
ROFF
wale;
vb
Yy
Ko \
y
\<
A
LK
NK
Lo f
Ht
MIN ,
\ MAK
TONE
LEVEL
Boss
CE-300
SUPER
CHORUS
t
POWER
mon
OFF
Microphone
Electric Guitar
Keyboard
Tape Recorder
fovemoan f, GvemaaD | oven 00
Speaker
@) Turn the Effect Switch on.
@ Connect the output of a musical instrument or the Echo
(Effect) Send to the Input Jack.
@ The CE-300 has the rated input level of —20dBm, there-
fore a microphone cannot be directly connected to the Input
Jack. (Use the Mixer BX-400.)
e
If both Input Jacks on the front and rear panels are used
at a time, the one on the front panel has priority.
@) To obtain natural and rich chorus effect, you may connect
the both
Output A and
B to the amplifiers'
inputs.
For
monaural output, however, use the Output Jack A(A+B).
e The both Outputs on the front and rear panels can be in
use at a time.
Power Amplifier
Output Jack
Speaker
Amplifier
Amplifier
) Rotate the Input Level Control until desirable volume is
obtained.
@ The appropriate position is where the Input Level Indi-
cators up to + 6aB light up.
@ If the signal exceeding the maximum input level (over +
12dBm) of the CE-300 has been fed, the created sound may
still be distorted even if input level is set to low.
@) Set the Modulation Rate, and Modulation Depth Controls
to around the blue markings. Then while actually listening the
sound, set them to your taste.