Magellan RoadMate Pro 5190T User Manual page 25

2. Tap 2D
to switch the map to 3D mode from 2D mode.
3. Tap .
Setting Zoom Levels
Select the zoom level that best suits your needs. Note that zoom levels are
limited in 3D mode. As you zoom out in 3D, the display will switch to 2D at
higher zoom levels.
1. Tap the '+' or '-' zoom level buttons at the bottom of the display to set the
desired zoom level.
Panning on the Map
1. While viewing the Map screen, slide your finger or a stylus across the
map.
2. The map screen changes to Pan mode.
3. When finished, tap
Routing to a Panned Position
1. Pan the map until the location you wish to route to is displayed.
2. Tap on the map at the point you want to go to. A red push pin will be
displayed along with information about the point chosen at the top of the
screen.
3. Tap the
4. If an active route already exists, first you need to define what to do with
this new route point:
Replace Destination: the next destination is cleared and replaced with
the one selected from the Pan screen.
Go There Now: the selected location is inserted in the route as an
intermediate destination before the next destination.
Add To Trip: the selected destination is added to the end of the current
trip.
5. Tap the large GO
begin navigating.
to switch the map to 2D mode from 3D mode, or tap 3D
and the map returns to your current position.
button in the top left corner.
button on the right to return to the Map screen and
17