Servicing - Zanussi WD 2290 Instructions For The Use And Care

Washing powder should only be placed
in the dispenser immediately prior to
the start of a programme. Do not leave
washing powder in the dispenser for
any length of time as it may form
lumps which can be difficult to
dissolve.
It is advisable to inspect the filters in
the water inlet hoses periodically and
clean if necessary.
Servicing
Should servicing be required for this
appliance contact your local Service
Agent but before requesting service the
following simple checks may save you
inconvenience and expenses:
• The machine won't start
Check that:
the plug is firmly in the wall socket
and that there is an electricity supply
by plugging in another appliance;
the door of the machine is firmly
closed:
the programme control knob is actually
pulled out:
make sure the fuses of your electrical
installation have not blown.
• The machine won't fill
Check that:
the water tap is turned on and
that there is sufficient pressure;
the fill hose is not sharply bent.
• The machine fills, but the water
empties from the drain hose
Check that:
the end of the drain hose is not placed
too low from floor level.
• The machine won't drain or spin
Check that:
the drain hose is not sharply bent
(kinked) or placed in such a way as to
obstruct a normal water flow;
the drain filter is not clogged.
• The machine vibrates or is too noisy
Check that:
the inner packing (transit security) was
correctly removed, as described in
paragraph «Unpacking»;
the machine is correctly levelled as
described in the relevant paragraph the
washer is not too close to a wall or to
the furniture.
14