Table of Contents
Advertisement
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the USB/audio board:
1.
Remove the Mylar (1) from the top of the board.
2.
Disconnect the cable from the ZIF connector (2) on the USB/audio board.
3.
Remove the two Phillips M2.0 × 3.0 screws (3) that secure the board to the computer.
4.
Lift the inside of the board up first, and then remove the board from the computer (4).
34
Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
29).
Battery on page
30).
Advertisement
Table of Contents
