Visioneer 9650 Installation Manual page 2

Usb scanner

User manual (158 pages)

Table of Contents

C O P Y R I G H T I N F O R M A T I O N

Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws.

The Visioneer brand name and logo are registered trademarks of Visioneer, Inc. The PaperPort brand name and logo are registered trademarks of ScanSoft, Inc.

Microsoft is a U.S. registered trademark of Microsoft Corporation. Windows is a trademark of Microsoft Corporation. TextBridge is a registered trademark of

Information is subject to change without notice and does not represent a commitment on the part of Visioneer. The software described is furnished under a

licensing agreement. The software may be used or copied only in accordance with the terms of such an agreement. It is against the law to copy the software on

any medium except as speciﬁcally allowed in the licensing agreement. No part of this document may be reproduced or transmitted in any form or by any

means, electronic or mechanical, including photocopying, recording, or information storage and retrieval systems, or translated to another language, for any

purpose other than the licensee's personal use and as speciﬁcally allowed in the licensing agreement, without the express written permission of Visioneer.

Part Number: 05-0486-300

Restricted Rights Legend

Use, duplication, or disclosure is subject to restrictions as set forth in contract subdivision (c)(1)(ii) of the Rights in Technical Data and Computer Software

Clause 52.227-FAR14. Material scanned by this product may be protected by governmental laws and other regulations, such as copyright laws. The customer

is solely responsible for complying with all such laws and regulations.

FCC Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for the class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and if not installed, and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment has been certiﬁed to comply with the limits for a class B computing device, pursuant to FCC Rules. In order to maintain compliance with

FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in

interference to radio and TV reception. The user is cautioned that changes and modiﬁcations made to the equipment without the approval of manufacturer

could void the user's authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that may cause undesired operation.

Table of Contents