Table of Contents
Advertisement
6. Use the leading string to make a knot on the servo
extension.
7. As the holes in the ribs are very small, it will be
easier to pull the string if you tape the extension
cord end to the leading string in a tapered fashion
as shown.
8. Pull the string out from the hole slowly, using
needle-nose pliers or tweezers.
ASSEMBLY / WING
9. Locate the Hatch Cover and trim it along the
molded line. Cut a hole as an exit for pushrod and
drill holes at each corner with 1/16"(1.5mm) drill bit.
1.5mm
10.Cut the servo horn as shown. Connect the servo
to your receiver and set up your radio to make
sure the direction is correct. Do not secure the
servo at this moment.
11.Locate the clevis and the pushrod. Thread the
clevis onto the pushrod at least 1/4" (6mm). Cut
small piece of silicone tube about 1/8" (3mm) and
slide it onto the clevis.
6mm
3mm
Advertisement
Table of Contents
