Table of Contents
Advertisement
BEFORE REQUESTING SERVICE
A
WAR, NIN G
Electrical Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems.
Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
POSSIBLE CAUSE
Cleaner
will not run.
1. Unplugged at wall outlet.
. On/Off switch not turned on.
. Tripped circuit breaker/olown
fuse at household service panel.
Poor job of dirt
pickup.
. Full or clogged dust bag.
. Carpet/bare floor setting incorrect.
. Broken belt.
. Clogged hose or nozzie.
. Hose not inserted fully.
. Wom agitator assembly.
. Hole in hose.
. Dust cover improperly installed.
. Belt not installed on motor shaft.
POSSIBLE SOLUTION
1. Plug in firmly. Push On/Off switch
to On.
2. Push On/Off switch to On.
3. Reset circuit breaker or replace
fuse.
1. Change bag.
2. Set In the correct position.
3. Replace belt.
4, Clean hose or nozzle area.
5. Insert hose.
6. Replace agitator assembly.
7. Replace hose.
8. Properly install dust cover.
9. Install belt on motor shaft.
Bare floor option | 1. Belt improperly installed with bare | 1. Property install belt.
willl not work.
floor selector in wrong position.
Light will
not work.
Dust escapes
the paper bag.
1. Bag Improperly installed.
2. Bag torn.
1, Burned out light bulb.
1. Replace light bulb.
1. Properly install bag.
2. Replace bag.
Dirt Sensor wili
1. Dirty optic cells.
1. Clean optic cells.
not work.
Advertisement
Table of Contents
