Replacing The Motor - Fisher & Paykel DishDrawer DD60DI9 Service Manual

8.20 Replacing the Motor

1 Remove the tub as per section 8.13
2 Remove the wiring cover as per 8.16
3 Remove the wiring harness to the stator, you will need to depress
the clips to remove the small spade terminal.
4 First check the windings are OK, this can be done from coil to
star and should read approx 8 ohms.Phase to phase connection
should read approx 16 ohms.
5 To remove the motor assembly from the tub, unclip the drain hose
cuff.
6 Remove the 6 torx screws securing the motor locking ring
assembly to the tub.
7 Lift the assembly and pull it from the sump to release the drain
spigot outlet.
8 To reassemble, ensure the motor stator has the gasket correctly
fitted, fit the motor locking ring to the upper side of the assembly,
locate the spigot to the sump and push forward to seat the o-ring.
9 Gently push the motor down into place and secure with the
locking ring, ensure all 6 torx screws are fitted and tight, refit the
drain hose and wiring and reassemble the wiring cover.
8 SERVICING PROCEDURES
phase to star
8 ohms
phase to phase
16 ohms
Drain hose cuff
motor
locking ring
50