Usb 3-4 Switch; Bluetooth Switch; Fx Footswitch Jack [Profx10V3+ And Profx12V3+] - Mackie ProFXv3+ Series Owner's Manual

Multi-channel analog mixers with enhanced fx, usb recording modes, and bluetooth

Table of Contents

PROFXV3+ MULTI-CHANNEL ANALOG MIXERS WITH ENHANCED FX, USB RECORDING MODES, AND BLUETOOTH®

USB 3-4 Switch

When engaged, this switch overrides the respective inputs on the channel – chs. 3/4 on the ProFX6v3+,

7/8 on the ProFX10v3+, and 9/10 on the ProFX12v3+ – and allows the USB return – stereo playback of Spotify®

or a DAW via the USB connection, for example – to flow through the signal path instead. Like any other input, this

signal may also be EQ'd, sent to an aux bus, or mixed in with the other signals and assigned to a subgroup or the main outs.

There is additional information about the USB 3/4 Return Switch, including setup help and other tips and tricks

in Appendix C on page 66.

Mixers can only accept one input per channel and the ProFXv3+ Series lineup is no different. This switch will engage

the channel's pairing mode, allowing the mixer to be seen by other Bluetooth devices such as a phone or tablet.

If Bluetooth is disengaged, then the mixer will use the analog input signal. However, when connected via Bluetooth,

then you have chosen to use the Bluetooth signal instead.

Pairing and Connecting – Press and hold the Bluetooth button for a few seconds to select it. The button will slow flash blue

when selected. This is to indicate that the ProFXv3+ mixer and device are in pairing mode.

While the ProFXv3+ mixer is in pairing mode, simultaneously scan for Bluetooth devices on the phone or tablet.

You should see ProFXv3+ appear in the "available devices" list. Select it. From there, the device should indicate

that it is successfully connected. Additionally, the Bluetooth' button on the mixer will be solid instead of flashing.

A previously paired device will auto reconnect if both the device and mixer are powered on and in range.

The Bluetooth may disconnect when affected by Electrostatic Discharge [ESD].

Manually reconnect the Bluetooth connection.

This 1/4" TRS connector is where to connect your favorite footswitch. This allows you to easily mute or un-mute the internal ef-

fects at will. Any one-button on/off footswitch will work.

If the internal FX have already been muted with the internal FX mute switch, then the footswitch has no effect.

Table of Contents