Intended Use - Dometic EA24B Short Installation And Operation Manual

EA24B, EA24D
• Do not use electrical devices in the compartments of the device unless they are rec-
ommended by the manufacturer for the purpose.
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Electrocution hazard
• Before starting the device ensure that the power supply line and the plug are dry.
• Disconnect the cooling device from the power supply:
– Before each cleaning and maintenance
– After every use
Health hazard
• Check if the cooling capacity of the device is suitable for the storage of the drinks to
be cooled.
• Store only closed and still sealed bottles in the device.
• Opening the door for long periods can cause significant increase of the temperature
in the compartments of the device.If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the door open to prevent mold developing within the device.
A
NOTICE! Damage hazard
• Never immerse the device in water.
• Protect the device and the cable against heat and moisture.
3

Intended use

The beverage storage appliance (also referred to as beverage center) is intended to be used exclusively for the stor-
age and temperature control of beverages. It is suitable as mobile outdoor built-in beverage center.
This beverage center is not intended to be used as a freestanding appliance.
The beverage center is not suitable for:
• Freezing foodstuff
• Storing food
• Medicines and other medical products
• Installation in vehicles
• Installation on boats, yachts or ships
• Storing corrosive substances or substances that contain solvents
• Commercial or retail use
This beverage center is only suitable for the intended purpose and application in accordance with these instruc-
tions.
This manual provides information that is necessary for proper installation and/or operation of the beverage center.
Poor installation and/or improper operating or maintenance will result in unsatisfactory performance and a possi-
ble failure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect assembly or connection, including excess voltage
EN
Intended use
19