Grill/Griddle Burner Adjustment - Viking DEVDSC305 Installation Manual

GRILL/GRIDDLE BURNER ADJUSTMENT

Grill (Illustration 3)
1. The grill burner orifice and air shutter are located beneath the front
end of the grill assembly. To gain access to the adjsutments,
remove the grill grate, flavor generator plates, grate support, and
the burner shield.
2. Remove the screw at the front and rear of the burner.
3. Lift the tube burner off the orifice and locate the air shutter
adjustment screw at the end of the burner.
4. Loosen the screw and adjust the air shutter to the desired setting.
(for natural gas open shutter approximately 7/16" [1.1 cm]; for
LP/Propane gas open the air shutter approximately 3/8" [0.98 cm]).
5. Tighten the screw, then replace tube burner on orifice.
6. Check flame for desired height before replacement of the above
parts.
7. Open the air shutter gap to eliminate yellow tipping.
8. Close the air shutter gap to prevent a noisy flame that lifts off the
burner.
TUBE
Screw (rear of burner)
BURNER
Griddle (Illustration 4)
1. To gain access to the air shutter, remove grates and grate supports located on either side of the griddle. Lift and
remove griddle.
2. Remove the metal plate located below the burner.
3. Remove the screws at the front and rear ofthe burner, remove the burner tube and locate the air shutter adjustment
screw at the end of the burner tube.
4. Flame adjustments are the same as grill - see #4-#7 under Grill.
5. Replace all griddle parts, griddle, grate supports, and grates.
12" Grill Assembly
1. Grill Grates
2. Flavor Generator
plates
3. Heat Deflector
4. Grill Frame
Screw (front of burner)
Air shutter
12
24" Grill Assembly
1
2
3
4
5
6
5. Grill Burner Sheild
(Do not remove
from burner)
6. Burner
(Do not remove)
Illustration 3
Air shutter adjustment screw