Viking Designer DERT301-4B Installation Instructions Manual page 13

IMPORTANT: LEVELING/ADJUSTMENTS/ALIGNMENT
Closely follow the procedures below to ensure proper performance and appearance of the range.
1. If the floor is smooth and level, level the unit with the screw thread of the legs. Set the high corner of the range so
that the the top of the grate support is 3/8" (.95cm) above the countertop, and level the range to the high corner.
2. If the floor is uneven or has a decided slope, level the unit with metal shims, as the adjustment required may exceed
the thread available in the leg.
3. After the range is properly leveled, the drip tray handle may be aligned by loosening the screws and adjusting the
handle horizontally within the limits provided by the slotted screw holes.
4. A level should be placed across the top of the range and the unit leveled both front-to-back and side-to-side. If it is
not level, burner combustion may be erratic, liquid, or semi-liquid batters will cook at an angle, and the unit may
not function efficiently.
Identification Label Location
(located behind door)
All ranges are tested before leaving the factory. When the range is connected to the electrical service, the installer
should use the "Performance Checklist" for his final checks.
When adjustments are required, contact your dealer/installer for corrections. If assistance is not available, contact
Viking Range Corporation Preferred Service for the nearest authorized service agent at (888) 845-4641. All corrections
to installation are the responsibility of the dealer/installer or end user.
B B A A
13
A. Right Side
Front / Back
Adjustable Legs
B. Left Side
Front / Back
Adjustable Legs