Sony STR-DE185 Operating Instructions Manual page 22

Troubleshooting (continued)
The remote does not function.
• Point the remote at the remote sensor m on the
_ceiver.
• Remove any obstacles in the path between the
_mo_e and [h_ _cei ver.
• Replace both bat_fies ill the remote with new
ones, if they are weak.
• Make sun you select the CoTTect function on the
_mot_.
• ]f the remote is ,set to opera_ the TV only, rise
the _mote to select a Sot]ice or component other
thai TV I_re ope_ing the receiver or other
component.
Clearing the receiver's memory
TO clear See
A]I memorized sel_ings page 11
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
40 - 20,000 Hz; rated I00 watts per channel
minimum RMS power, with no more than
0.09 % total harmonic distortion fi'om 250
milliwatls to rated output (Models of area code
U only).
Amplifier section
POWER OUTPUT
Models of area code U
Rated Power Output at Stereo Mode
(8 ohms 40 Hz 20 kHz, THD 0.09 %)
100W+ 100W
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms I kHz, THD 0.7 %)
!00W+ 100W II
I) Measured under the following conditions:
Area code Power requirements
CEL, CEK 230 V AC, 50 Hz
Frequency response
CD, MD/TAPE, 20 Hz 50 kHz
VIDEO I, VIDEO 2 +0/-Ik5 dB (wi_h bass
boost bypassed)
Inputs (Analog)
CD, MD/TAPE, Sensitivity: 250 mV
VIDEO I, VIDEO 2 Impedance: 50 kilohms
S]Ne_: 85 dB
(A, 250 mV 3_)
2) INPUT SHORT.
3) Weighted network, input leveh
Outputs
MD/TAPE, VIDEO 1 Voltage: 250 mV
Impedance: 10 kilohms
Bass Boost:
+8 dB at 70 Hz
Tone: ±10 dB a_ 100 Hz and
10kHz
22G8