Table of Contents
Advertisement
2-4.
UPPER
DRUM
REMOVAL
As illustrated below, in the case that the cap screws are removed to
adjust the cylindrical
degree and to replace RD for maintenance
service. Remove
them by the hexagonal wrench (Subtense 3 mm)
after removing the ASS'Y of the slack detecting unit.
It is due to the reason why the cap screw can not be turned so that
the hexagonal wrench may touch to the shaft portion of the slack
detecting arm (B).
®
Remove PSW3 x 6, and take up it
from the pinch fitting lever shaft.
Slack detecting ARM (8).
@
Remove the pulling
coil spring from
the pinch fitting
lever pin.
Slack detecting unit ass'y
Cap screws
hexagonal wrench
(subtense 3mm)
The cap screw of this side can not be turned.
Advertisement
Table of Contents
