Fastening The Dishwasher To The Cabinet - Viking DFUD042 Installation Instructions Manual

FASTENING THE DISHWASHER TO THE CABINET

WARNING!
The dishwasher door will not stay open by itself until the door panel is installed. Be aware of this when fastening
the dishwasher to the cabinet.
Fasten the dishwasher to a kitchen cabinet using the 1" (2.5 cm) screws provided.
NOTE: It is necessary to secure the dishwasher with screws so that it does not tilt if something heavy is placed on the
door.
1. Using the screws and spacers, fasten the dishwasher to the cabinet through holes A.
2. Plug holes A with plastic plugs provided.
3. When the machine is properly fastened, check that the feet are tight against the floor and the machine is level.
installing the kickplate
First, replace the guard plate and toe kick brackets (see page 8). Adjust the bracket depth to allow for the thickness of
the kickplate. First, pull or push the bracket to the required depth, less the thickness of the kickplate. Then, push the
gray tab towards the outside edge of the unit until it locks the bracket into place.
Once the toe kick brackets are in place, install the kickplate as follows:
1. Remove kickplate and felt insulation from the packaging.
2. Peel the adhesive protection strip off the insulation and press it firmly to the back side of the kickplate, making sure
not to cover any slots on the kickplate.
3. Fit the kickplate over the toe kick brackets so that the kickplate is held securely in place. Adjust the kickplate in a
way that it maintains contact with the floor.
11