Advertisement
IMpORTANT SAFETy INFORMATION
Safety Warnings and precautions
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
1.
Electrical shock can cause death
or injury! NEVER TOUCH exposed
conductors of electricity.
2.
Test cable voltages with care.
Only use one hand when securing
the clamp around cable.
3.
Inspect the Meter before use. In
addition to a general inspection,
look specifically for:
a. Pay special attention to the
insulation protecting the connectors.
b. Check the leads for exposed metal,
damaged insulation, and continuity.
c. Replace damaged test lead
immediately, before use.
4.
Do not use the Meter if:
a. The test lead is damaged
in any way.
b. The battery is low.
c. Near any explosive
gasses or fumes.
d. Any abnormal operation is
detected.
(If in doubt about the condition
of the Meter, have it serviced.)
e. Any abnormal operation is
detected.
(If in doubt about the
condition of the Meter, have
it serviced before use.)
f. The battery cover is open.
Item 59458
For technical questions, please call 1-888-866-5797.
5.
This Meter should be powered only by
3, correctly installed AAA batteries.
6.
Use caution when working near
voltages above 30 VAC rms, 42 VAC
peak, or 60 VDC. Voltages this high
present a risk of electric shock.
7.
Connect the common (COM) test
lead first and disconnect it last.
8.
Hold the probes with fingers
behind guards.
9.
Avoid electrical shock. Use extreme
caution when working near uninsulated
conductors or bus bars. Prevent body
contact with grounded surfaces such
as pipes, radiators, ranges, and cabinet
enclosures when testing voltages.
10. Observe work area conditions. Do
not test voltages in damp or wet
locations. Don't expose to rain.
Keep work area clean and well lit.
11. Keep children away. Children must
never be allowed in the work area.
12. Stay alert. Watch what you are doing,
use common sense. Do not operate
any Meter when you are tired.
13. Do not operate Meter if under the
influence of alcohol or drugs. Read
warning labels on prescriptions to
determine if your judgment or reflexes
are impaired while taking drugs. If there
is any doubt, do not operate the Meter.
Page 3
Advertisement
