Specifications - Sony BKM-120D Installation Manual

BKM-127W NTSC/PAL Input Adaptor
Assigning input signals to connectors
Before inputting signals to the BKM-127W, you must
specify the type and format of the signal that will be
input to each connector.
For information about the signal assignment, refer to the
manual of your video monitor.
Signal assignment is not necessary for the LMD series
monitors.
Note
After assigning input signals to each connector, carry
out AUTO adjustment in the CONTROL PRESET
ADJ menu.

Specifications

General
Power requirements +5 V, ±6 V
Power consumption 3 W
Operating conditions
Temperature 0°C to 35°C (32°F to 95°F)
Optimum temperature
20°C to 30°C (68°F to 86°F)
Humidity 0% to 90% (no condensation)
Pressure 700 hPa to 1060 hPa
Storage and transport conditions
Temperature –10°C to 40°C (14°F to 104°F)
Humidity 0% to 90%
Pressure 700 hPa to 1060 hPa
Maximum external dimensions
25 × 162 × 122 mm
(1 × 6
(1-slot size)
Mass 270 g (10 oz)
Input/output connectors
Analog composite signals
BNC × 2, high impedance, with loop-through output
and 75-ohm automatic termination
YC signals
4-pin mini DIN × 1, with loop-through output and 75-
ohm automatic termination
6
(E)
× 4
1 7
/ / inches)
2 8
Signal characteristics
Analog composite, YC signals
Signal level
Analog composite
1 Vp-p +3 dB/–6 dB
YC Y: 1 Vp-p ±6 dB
C: 0.286 Vp-p ±6 dB (NTSC
burst signal level)
0.3 Vp-p ±6 dB (PAL burst
signal level)
Luminance signal
Frequency characteristics
Analog composite
Monochrome signal:
50 Hz to 6 MHz ±2 dB
Color signal: –30 dB relative to
subcarrier frequency
YC Y: 50 Hz to 6 MHz ±2 dB
Chrominance signals
Demodulation axis
R–Y/B–Y
Subcarrier synchronization range
±200 Hz min.
Chroma phase adjustment range (NTSC)
±10° min.
Accessories supplied
Installation Manual (1)
Design and specifications are subject to change
without notice.