Samsung NX60 83 S Series User Manual page 93

Surface burner
Problem
All burners do not The power cord is
light. not plugged into the
electrical outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped.
The gas supply is not
properly connected or
turned on.
Surface burners do The control knob is not
not light. set properly.
The burner caps are not
in place.
The burner base is
misaligned.
Surface burner The control knob has
clicks during been left in the Lite
operation. position.
The burners do not Surface burner
burn evenly. components and caps are
not assembled correctly
and level.
The surface burners are
dirty.
DG68-01327A-02_IB(FULL)_NX60A8315SS_AX_MES+EN.indb 43 DG68-01327A-02_IB(FULL)_NX60A8315SS_AX_MES+EN.indb 43
Cause Action
Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the
circuit breaker.
See the Installation
Instructions that came with
your range.
Push in the control knob and
turn it to the Lite position.
Clean the electrodes.
Put the burner cap on the
burner head.
Align the burner base.
After the burner lights, turn
the control knob to a desired
setting.
If the burner still clicks, contact
a service technician.
See page 36.
Clean the surface burner
components.
(See page 36.)
Problem Cause
Very large or The wrong burner orifice
yellow surface is installed.
burner flames.
Surface burners The oven door lock is
light but oven turned on.
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
Oven
Problem Cause
The oven control There may be an issue
beeps and displays with your oven. See the
an information "Information codes" chart
code. on page 47.
Action
Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press for 3 seconds.
The oven will beep and the
Lock icon will turn off.
Call a qualified service
technician.
Action
Press
Apagar/Borrar (OFF/CLEAR),
and then restart the oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
English 43
2023-10-30 오후 2:14:57 2023-10-30 오후 2:14:57