Table of Contents
Advertisement
6 CS Maintenance Menu
6.1.
How to enter into CS Maintenance Menu
6.1.1.
Purpose
After exchange parts, check and adjust the contents of adjustment mode.
While pressing [VOLUME ( - )] button of the main unit, press [ RED ] button of the remote control three times within 2 seconds.
Note:
CS Maintenance Menu can not be entered when 3D signal input.
Input 2D signal to enter CS Maintenance Menu.
6.1.2.
Key command
Press the Cursor key [Up/Down] on the remote control to select the functions.
6.1.3.
How to exit
Press the [EXIT] button on the remote control.
6.2.
Repack
1. Select [OPT] in CS Maintenance Menu.
2. Press [OK] button or Cursor key [Right] on the remote control.
Exit:
Press the [Exit] button or the [Return] button on the remote control.
11
Advertisement
Table of Contents
