Table of Contents
Advertisement
Installation
Remote control battery installation
Replacing batteries
Replace batteries by following the steps below:
Requires two AA batteries.
1. Open the battery cover.
\
2. Install the batteries as shown
in the battery compartment.
(Polarity + or- must match the
markings in the compartment).
JJ2 -.Two
AA size
3. Replace the cover.
/_
Precaution
on
battery
use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control
transmitter.
Observe the following
precautions:
1. Always use new batteries when replacing the old set.
2.
Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3.
Battery replacement is necessary when remote control acts sporadically or stops operating this unit.
Notes:
• Do not drop, apply shock to or step on the remote control.
• Do not spill water on the remote control.
• Do not place objects between the remote control and remote control receiver.
• Do not use remote controls for other equipment at the same time.
• If the TV does not operate even when operating the remote control from a close range, it is time to
replace the batteries.
Refer to the label on back of the remote control for directions on replacing batteries.
I Maintenance
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap and
water solution or a weak detergent solution.
• Use eyeglass cleaner to remove stubborn dirt from the LCD.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using a chemically treated cloth, read the instructions that came
with the cloth carefully.
CAUTION :
If water or similar substances get inside the monitor via the liquid crystal panel surface, a malfunction may result.
7
Advertisement
Table of Contents
