Yamaha TTR 125 2023 Manual page 53

Periodic maintenance and adjustment
down sufficiently before remov-
ing the oil filler cap.
NOTICE: Do not operate the ve-
hicle until you know that the en-
gine oil level is sufficient.
7
1. Engine oil filler cap
TIP
The engine oil should be between the
minimum and maximum level marks.
[EWA17640]
[ECA10012]
1. Maximum level mark
2. Minimum level mark
4. If the engine oil is at or below the
minimum level mark, add suffi-
cient oil of the recommended type
to raise it to the correct level.
5. Check the O-ring for damage, and
replace it if necessary.
6. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
1. Engine oil drain bolt
4. Install the drain bolt and its new
5. Refill with the specified amount of
7-9
and engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
gasket, and then tighten the bolt
to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
the recommended engine oil.
Recommended engine oil:
See page 9-1.
Oil change quantity:
1.00 L (1.06 US qt, 0.88 Imp.qt)