Table of Contents
Advertisement
en Installation instructions
17.4 Installing below a hob
If the appliance is installed below a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
Hob type
Induction hob
Full-surface induction hob
Gas hob
Electric hob
Secure the worktop to the built-in unit. Observe the in-
stallation instructions for the hob.
17.5 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
¡ Ensure that the intermediate floor has a gap to the
installation wall in order to ventilate the appliance.
22
The minimum worktop thickness
the required minimum clearance
raised in mm
49
70
39
39
¡ If the tall unit has another back panel in addition to
¡ Only fit the appliance up to a height which allows
17.6 Installing two appliances on top of
each other
Your appliance can also be installed above another ap-
pliance.
17.7 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡ The fuse protection must correspond to the power
¡ The appliance corresponds to protection class I and
¡ The appliance must be disconnected from the
¡ Contact protection must be ensured by the installa-
¡ Only a licensed professional may connect appli-
Electrically connecting an appliance without a
protective contact plug
Note: Only licensed specialists may connect the appli-
ance. Damage caused by incorrect connection is not
covered under the warranty.
An isolating switch must be integrated into the perman-
ent electrical installation according to the installation
regulations.
flush in mm
50
70
50
42
the element back panels, this must be removed.
accessories to be easily removed.
rating specified on the appliance's rating plate and
to local regulations.
must only be operated with a protective earth con-
nection.
power supply whenever installation work is being
carried out.
tion.
ances without plugs. They are subject to the require-
ments of the local electricity provider.
is determined by
.
in mm
5
5
5
2
Advertisement
Table of Contents
