Table of Contents
Advertisement
4. Composer
When the Song load is complete, you'll see the following screen for a moment before returning to the Master
Screen :
7
7
If the Song data has already been saved in the internal memory when you try to start the load
operation in step , you'll see the following screen :
Press (ENTER) again if you're sure you want to go ahead and load the new data, deleting
(overwriting) the data that's already there. If you decide, however, that you actually did want to keep
the material you already had in memory, press (EXIT) at this point and save the Song data onto
another Memory Card. Then perform the load procedure again.
If you didn't make changes in the loaded song or add something to it, the above message wan't
appear.
6. Deleting Song Data in
the Internal Memory ~Delete
The KR-3500 can only contain one Song at a time in its internal memory. Consequently, you should delete
that Song before re-recording, or before beginning work on a new Song.
Operation
From the Master Screen :
@) Press
(REC)
while holding down
(DEMO |)
REC
@) Press
CENTER ) and User Program loading will begin immediately.
85
Advertisement
Table of Contents
