27
PB-8010, EB810
FUEL SYSTEM
4-4 Replacing fuel lines and grommet
Removing
1. Open fuel cap. Then, pull off outer fuel line (a1)
B
a1
and fuel return line (B) from carburetor, pinching
clips (F).
2. Remove fuel line grommet (C) from fuel tank,
together with outer fuel line (a1), fuel return line (B)
and tank vent line (D).
Fuel strainer can be directly pulled out through the
D
grommet hole.
C
3. Remove fuel strainer (G) and inner fuel line (a2).
F
4. Remove protect tube (E).
a1
5. Remove outer fuel line (a1), fuel return line (B)
B
and tank vent line (D).
6. Inspect lines (a1), (a2), (B), (D) and grommet (C).
E
Replace them if damaged.
H
Installing
1. Insert lines as shown.
Distance (d1): 15 mm (0.59 inch)
(d1)
NOTE: Make sure outer fule line (a1) and fuel re-
turn line (B) are inserted fully onto short nipple of
pipe joints.
C
NOTE: Make sure tank vent line (D) and inner fuel
D
line (a2) are secured with clips (H) as shown.
2. Cover outer fuel line (a1) and fuel return line (B)
H
by protect tube (E).
a2
3. Reinstall fuel grommet (C) to fuel tank, together
with lines and fuel strainer (G).
G
4. Connect outer fuel line (a1) and fuel return line
(B) to carburetor with clips (F).