Installing Rewind Spring - Echo shindaiwa PB-8010 Service Manual

10

2-3 Installing rewind spring

WARNING
Wear eye protection and take care when
removing rope reel. Rewind spring may un-
wind suddenly and cause personal injury.
R
M
STARTER SYSTEM
DANGER
Q
S
m1
d2
D
If rewind spring is popped out unexpectedly, follow
steps 1) to 13) to install it into original position.
1) Due to large spring load, it is recommended to
use the following tool.
2) This tool can be made by assembling suitable
board (Q), bolt or bar (R; < 13 mm dia.) and bolt
or bar (S; < 3 mm dia.) as follows.
< 13 mm dia.
R
S
< 33 mm
3) Set inner hook (m1) of rewind spring on rib (d2)
of rope reel as shown.
4) Turn over rope reel (D) with rewind spring (M)
and install the tool for winding spring as shown.
NOTE: Set rewind spring (M) inside the small bolt
or bar (S) as shown.
5) Turn rope reel (D) with rewind spring (M) coun-
terclockwise to wind the spring.
PB-8010, EB810
< 3 mm dia.
< 4 mm
Q
S
M