Adding Channels To The Tv's Memory - Toshiba 34HF85 Owner's Manual

÷
÷
mage tilt correction
When you instalI or change the direction of the TV, the picture may
become tilted (caused by the Earth's magnetism.) If this happens, use
the image tiIt correction feature to obtain the best possible picture.
To adjust the image tilt:
1. Press MENU, then press _ or
until the SETUP menu appears.
2. Press & or V to highlight IMAGE
TILT.
3. Press 4 or _ to adjust the picture
tilt (from -10 to 10.)
c L O ._ D CAPTION OFF
mCTUR_ ._1Z _
PICTUR_ SCROLL
C_NEmA MOD_ VlOEO
ASPECT ON
_ : SELEC r <_t :AO,_US r
Adding channels to the TV's memory
When you press CN/_ or % your TV will stop only on the channels you
have stored in the TV's channel memory. Follow the steps below to
program channeIs into the channel memory.
Programming channems automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase channels manually.
To add channels automatically:
1. Press MENU, then press 4 or _ to display the SETUP menu.
2. Press & or V until the TV/CABLE
selection is highlighted.
3. Press 4 or _ to higMight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cane, choose CABLE.
_ETUP
L_UAGE EN_LUSH
C_QCK _EZ I_:DOAM
a_D_E_aS_ ADD
4. Press _ until the CH PROGRAM selection is highlighted.
5. Press ,,_or _ to start channel programming. The TV wilI automatically
cycle through all the TV or Cable channels (depending on which you
selected), and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
"PROGRAMMING NOW-PLEASE WAIT" appears.
6. When channel programming is complete, the message "COMPLETED"
appears.
7. Press CN/\ or v to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you can add
or erase specific channels manually.
To add or erase channels manually:
1. Select the channel you want to add or erase. If you are adding a
channel, you must select the channel
using the Channel Number buttons.
2. Press MENU, then press ,_ or _ to
display the SETUP menu.
3. Press & or _ to highlight ADD/
ERASE.
4. Press _ or I_ to select ADD or
ERASE, whichever function you want to perform.
5. Repeat steps 1-4 for other channels you want to add or erase.
S_TUP
_AN_UA_ E_L_SH
CLOCK SET _ABLE
TV CABLE
CH PRO€RAM
Channel
Numbers
Channel A v
Menu
÷
J3U00121A(E) P16-23 22 , 10/03/2005, 6:22 AM