Adding Channels To The Tv's Memory; Programming Channels Automatically; Adding And Erasing Channels Manually; Changing Channels - Toshiba COLORSTREAM 32A35 Owner's Manual

÷
÷
Adding channels to the TV's memory
When you press CH +/- on the remote control or CHANNEL A/V on
the TV front panel, your TV will stop only on the channels stored in the
TV's channel memory. Follow the steps below to program channels into
the memory.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase specific channels manually.
To add channems automatically:
1. Press MENU, then press _ or _ to display the SETUP menu.
2. Press _ or V untiI the TV/CABLE
selection is highlighted.
3. Press 4 or I_ to highlight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TM
If you use cable, choose CABLE.
DR PROGRAM START _*
ADD / ERASE ADD
SELECT A V ADJUST 4
4. Press V to setect CH PROGRAM.
5. Press _ or _ to start channel programming. The TV will automati-
caiIy cycle through alI the TV or CabIe channels (depending on
which you selected), and store alI active channels in the channel
memory.
While the TV is cycling through the channels, the message
"PROGRAMMING NOW-PLEASE WAIT" appears.
6. When channel programming is complete, the message "COMPLETED"
appears.
7. Press CH + or - to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you can add
or erase specific channels manually.
To add or erase channels manually:
1. Select the channet you want to add or erase.
If you are adding a channel, you must select the channel using the
Channel Number buttons.
2. Press MENU, then press ._ or
to display the SETUP menu.
3. Press A. or V to highlight ADD/
TV / CABLE CABLE
ERASE.
DR PROGRAM START
4. Press _ or _ to select ADD or _ASD ERASE
ERASE, whichever function you
want to perform.
SELECT AV ADJUST _
5. Repeat steps 1-4 for other
channels you want to add or erase.
Changing channems
To change to the next programmed channel:
Press CHANNEL _&/V on the TV front panel or CH +/- on the
remote control,
To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0-9 and 100) on the remote
control.
For example, to select channel 125, press 100, 2, 5.
- Channel
Numbers
- Channel +/-
- Menu
÷
16
J3N51621A(E) P07-16 16 _ 5/03/2005, 3:31 AM