Environmental Protection - IVT SNWB-163-RC Manual

Replacing the auger belt and drive belt
∙ Remove the belt cover on the front of the engine by
removing the self-tapping screws.
NOTE: drain the gasoline from the snow blower.
∙ Carefully pivot the machine up and forward so that
it rests on the auger housing. Remove the frame cover
from the underside of the machine by removing self-
tapping screws which secure it.
∙
For the drive belt, grasp the idler pulley and pivot it
toward the right.
∙ Roll the auger belt off the engine pulley.
For auger belt:
∙
Loosen and remove the shoulder screw.
∙ Unhook the support bracket spring from the frame.
∙ Remove the belt from around the auger pulley and
slip the belt between the support bracket and the auger
pulley.
NOTE: Do not forget to reinstall the shoulder screw
and reconnect the spring to the frame after installing a
replacement auger belt.
For drive belt:
∙
Lift the drive belt off engine pulley.
∙ Slip the drive belt off the pulley and between friction
wheel and friction wheel disc.
∙ Replace belt in the reverse order.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Centre. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE
13
Instruction manual
EN