Manual instruction | Snow blower
•
Unit running on CHOKE
RUN button to RUN.
•
Blocked fuel line or stale fuel
line; fill the tank with clean fresh gasoline.
•
Water or dirt in the fuel system
tank and carburetor. Refill with fresh fuel.
Loss of power
•
Spark plug wire loose
spark plug wire.
•
Gas cap vent hole plugged
snow from gas cap. Be certain vent hole is clear.
Excessive vibration
•
Loose parts or damaged auger.
engine immediately and disconnect the spark
plug wire. Tighten all bolts and nuts. If vibration
continues, have the unit serviced by an authorized
service dealer.
Unit fails to propel itself
•
Drive control cable in need of adjustment.
► Adjust drive control cable. Refer to Making
Adjustment Section.
•
Drive belt loose or damaged.
belt. Refer to the Service Section.
Unit fails to discharge snow
•
Chute assembly clogged
disconnect spark plug wire. Clean chute and inside
of auger housing with clean-out tool or a stick.
•
Shear pins sheared
•
Foreign object lodged in auger.
immediately and disconnect spark plug wire.
Remove object from auger.
•
Auger control cable in need of adjustment.
Adjust auger control cable. Refer to the Making
Adjustment Section.
•
Auger belt loose or damaged.
Section.
Environmental protection
Recycle raw materials instead of disposing
as waste.
Machine, accessories and packaging should be
sorted for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
EN
► Move the CHOKE/
► Clean the fuel
► Drain the fuel
► Connect and tighten
► Remove ice and
► Stop the
► Replace drive
► Stop engine and
► Replace shear pins.
► Stop engine
► Refer to Service
►
16