Table of Contents
Advertisement
Safety Precautions
, The,,ohtn,ng,,a
arrowhead w ithin a triangleis
CA UT IO N
intended
to tell the u ser that
partsinsidetheproductarea
riskof electricshockto persons,
The exclamation point within
a triangle is intended to
tell tile user that important
WARNING:
To reduce
the risk of electric
shock,
do not remove
cover
or back.
operating and servicing
No user-serviceable
parts
inside.
Refer servicing
to qualified
service
personnel,
instructions are in the
papers with the appliance.
This reminder
is provided
to direct the CATV system
installer's
attention
to Article 820-40
of the NEC that provides
guidelines
for
proper grounding
and, in particular,
specifies
that the cable ground
shall be connected
to the grounding
system
of the building,
as
close to the point of cable entry as practical.
_o,)
| I a[_iYL'_
_1_'_ [o]|
Slots and openings
in the cabinet and the back or bottom
are provided
for ventilation,
and to ensure reliable
operation
of the LCD
TV and to protect it from overheating.
These
openings
must not be blocked
or covered.
There should
be at least 10 cm of space
from these
openings.
The openings
should
never be blocked
by placing the LCD TV on a bed, sofa, rug or other similar surface.
This LCD TV should
not be placed
in a built-in
installation
such as a bookcase
unless proper
ventilation
is provided.
1)
Read these instructions.
2)
Keep these
instructions.
3)
Heed all warnings.
4)
Follow all instructions.
5)
Do not use this apparatus
near water.
6) Clean
only with dry cloth.
7)
Do not block any ventilation
openings.
Install in accordance
with the manufacturer's
instructions.
8)
Do not install near any heat sources
such as radiators,
heat registers,
stoves or other apparatus
(including
amplifiers)
that
produce
heat.
9)
Do not defeat the safety purpose
of the polarized
or grounding-type
plug. A polarized
plug has two blades with one wider than
the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided
for
your safety. If the provided
plug does not fit into your outlet, consult
an electrician
for replacement
of the obsolete
outlet.
10) Protect the power cord from being walked
on or pinched
particularly
at plugs, convenience
receptacles,
and the point where they exit from the apparatus.
11) Only use attachments
/ accessories
specified
by the manufacturer.
12) Use only with the cart, stand, tripod,
bracket
or table specified
by the manufacturer,
or sold with the
apparatus.
When a cart is used, use caution
when moving
the cart / apparatus
combination
to avoid injury
from tip-over.
13) Unplug this apparatus
during
lightning
storms or when unused
for long periods
of time.
14) Refer all servicing
to qualified
service personnel.
Servicing
is required
when the apparatus
has been damaged
in any way,
such as power-supply
cord or plug is damaged,
liquid has been spilled
or objects
have fallen into the apparatus,
the apparatus
has been exposed
to rain or moisture,
does not operate
normally,
or has been dropped.
15) Operate
only from the type of power source indicated
on the marking
label. If you are not sure of the type of power supplied
to
your home consult your television
dealer or local power company.
16) Follow all warnings
and instructions
marked
on the LCD TV.
17) Never push objects of any kind into this LCD TV through
cabinet
slots as they may touch dangerous
voltage
points or short out parts
that could result in a fire or electric
shock. Never spill liquid of any
kind on the LCD TV.
18) If an outside antenna
is connected
to the television
equipment,
be sure the antenna
system
is grounded
so as to provide
some
protection
against voltage
surges
and built up static charges.
In the U.S. Section
810-21
of the National
Electrical
Code
provides
information
with respect
to proper
grounding
of the mast
and supporting
structure,
grounding
of the lead-in wire to an
antenna
discharge
unit, size of grounding
conductors,
location
of
antenna
discharge
unit, connection
to grounding
electrodes,
and
requirements
for the grounding
electrode.
EXAMPLE
OF ANTENNA
GROUNDING
AS PER
(NEC)
NATIONAL
ELECTRICAL
...... ANTENNA
CODE
/
_
LEAD-IN
WIRE
-//'_ROU
N D CLAM P_.
_
//
_
_ANTENNA
IF_
_"/I DISCHARGE
UNIT
Igd_Oick-
I
[
I (NEC SECTION 810-20)
IEQUIPMENT
.I,_
_
"J
ZGROUNDING
-_ _:,,_:,,_:,,_:,,_
_
CONDUCTORS
__.._/_
(NECSECTION810-21)
"_
GROUND
CLAMPS
POWER
SERVICE
GROUNDING
ELECTRODE
SYSTEM
(NEC ART 250, PART H)
Advertisement
Table of Contents
