Replace A Corded Scanner Interface Cable; Replace Cables And Batteries In Cordless Systems; Replace An Interface Cable In A Base - Honeywell Voyager 147 Series User Manual

Replace a Corded Scanner Interface Cable

1. Turn the power to the host system OFF.
2. Disconnect the scanner's cable from the terminal or
3. Locate the small hole on the back of the scanner's handle.
4. Straighten one end of a paper clip.
5. Insert the end of the paper clip into the small hole and press
6. Replace with the new cable.

Replace Cables and Batteries in Cordless Systems

Replace an Interface Cable in a Base

1. Turn the power to the host system OFF.
2. Disconnect the base's cable from the terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector release
5. Replace with the new cable.
Voyager XP User Guide
computer.
This is the cable release.
in. This depresses the retention tab, releasing the connector.
Pull the connector out while maintaining pressure on the
paper clip, then remove the paper clip.
Insert the connector into the opening and press firmly. The
connector is keyed to go in only one way, and will click into
place.
clip.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
CCB01-010BT-V1N Base:
Cable
Release
209