Table of Contents
Advertisement
4.
Remove the base enclosure (see
5.
Disconnect the battery (see
If you are replacing a memory module, remove the existing memory module:
1.
Lift the clear film covering the memory module.
2.
Pull away the retention clips (1) on each side of the memory module.
The memory module tilts up.
3.
Grasp the edge of the memory module (2), and then gently pull the memory module out of the memory
module slot.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges only. Do
not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
Reverse this procedure to install a memory module.
Base enclosure on page
Battery on page
34).
32).
Component replacement procedures
43
Advertisement
Table of Contents
