Sony STR-DE935 Operating Instructions Manual page 50

Troubleshooting
No sound is heard from the center speaker. Radio stations cannot be tuned in.
=> Make sure the sound field function is on (press => Check that the antennas are connected securely.
SOUND FIELD — MODE). Adjust the antennas and connect an external
=> Select a sound field containing the word "cinema" antenna if necessary.
or "virtual" (see page 32~35). => The signal strength of the stations is too weak
=> Adjust the speaker volume (see page 22). (when tuning in with automatic tuning). Use
=> Make sure the center speaker size parameter is set direct tuning.
: to either SMALL or LARGE (see page 20). => Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning)
No sound or only a very low-level sound is heard (see pages 44 and 54).
from the rear speakers. => No stations have been preset or the preset stations
: => Make sure the sound field function is on (press have been cleared (when tuning by scanning preset
SOUND FIELD — MODE). stations). Preset the stations (see page 45).
; => Select a sound field containing the word "cinema" => Press DISPLAY so that the frequency appears in
i or "virtual" (see page 32~35). the display.
! i => Adjust the speaker volume (see page 22).
| => Make sure the rear speaker size parameter is set to No picture or an unclear picture appears on the
: either SMALL or LARGE (see page 20). TV screen or monitor.
| *» Select the appropriate function on the receiver.
The surround effect cannot be obtained. => Set your TV to the appropriate input mode.
=> Make sure the sound field function is on (press "> Move your TV away from the audio components.
SOUND FIELD - MODE).
=> Make sure that the SPEAKERS selector is set to A The remote does not function.
or B (not A+B) if you connected two sets of front => Point the remote at the remote sensor on the
speakers. receiver.
| => Remove any obstacles in the path between the
Recording cannot be done. remote and the receiver.
=> Check that the components are connected correctly. => Replace both batteries in the remote with new
: => Select the source component with a FUNCTION ones, if they are weak.
: button. => Make sure you select the correct function on the
, => When recording from a digital component, make remote.
| sure the input mode is set to ANALOG (see page => If the remote is set to operate the TV only, use the
27) before recording with a component connected remote to select a source or component other than
to the analog MD/DAT or TAPE terminals TV before operating the receiver or other
(STR-DE935) or the analog MD/TAPE terminals component.
(STR-DE835/SE591).
=> When recording from a digital component, make
sure the input mode is set to DIGITAL (see page Reference sections for clearing the
uoReUOjU] |eEUCHIPpy
27) before recording with the component receiver's memory
connected to the DIGITAL MD/DAT OUT Todi 5
terminals (STR-DE935) or the DIGITAL MD/TAPE ae bi
OUT terminals (STR-DE835/SE591). All memorized settings page 18
Customized sound fields page 40
52
ar OE OR np a een an