Table of Contents
Advertisement
8 | English
Technical Data
Cordless screwdriver
Article number
Rated voltage
No-load speed
– First gear
– Second gear
Impact rate
Max. torque, hard/soft screwdriving application accord-
ing to ISO 5393
Max. drilling diameter (first/second gear)
– Masonry
– Steel
– Wood
Screw diameter max.
Weight according to EPTA-Procedure 01:2014
Permitted ambient temperature
– during charging
B)
– During operation
and during storage
Recommended batteries
Recommended chargers
A) Depends on battery in use
B) Limited performance at temperatures <0 °C
Assembly
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Removing the battery (see figure A)
Use only the chargers listed on the accessories page.
u
Only these chargers are matched to the lithium-ion bat-
tery of your power tool.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the Electronic Cell Protection (ECP). A protective circuit
switches the cordless dust extractor off when the battery is
drained.
1 609 92A 4RJ | (17.12.2018)
GSR 10.8V-30
3 601 JG9 0..
V=
10.8
-1
min
0 – 420
-1
min
0 – 1600
Nm
30/18
mm
mm
10
mm
20
mm
kg
0.90
°C
0 to +45
°C
-20 to +50
GBA 10.8V..
AL 11.. CV
GAL 12.. CV
GAL 12V-..
GAX 18V-30
Do not continue to press the On/Off switch after the
u
power tool has automatically switched off. The battery
can be damaged.
To remove the battery (8), press the release button (7) and
pull the battery downwards out of the power tool. Do not
use force to do this.
Follow the instructions on correct disposal.
Changing the tool (see figure B)
The drill spindle is locked when the on/off switch (10) is not
pressed. This makes it possible to change the application
tool in the drill chuck quickly, conveniently and easily.
Open the keyless chuck (2) by turning it in the direction of
rotation ➊ until the tool can be inserted. Insert the tool.
Firmly tighten the keyless chuck (2) by turning it by hand in
the direction of rotation ➋. You will hear an audible click
from the GSB. The drill chuck is locked automatically.
The lock will disengage again if you turn the sleeve in the op-
posite direction to remove the tool.
GSB 10.8V-30
3 601 JG9 1..
10.8
0 – 420
0 – 1600
–
0 – 24000
A)
A)
30/18
–
8
10
20
8
8
1.0
0 to +45
-20 to +50
GBA 10.8V..
AL 11.. CV
GAL 12.. CV
GAL 12V-..
GAX 18V-30
Bosch Power Tools
Advertisement
Table of Contents
