Yaesu FT-101E Instruction Manual page 28

(4) Set the BAND switeh at 8&0, VPOQ at
PRESELECTOR -at
TC6 at the
and the
Set TCI
7 of the inner scale
and Hid-capacitance pone
OOO KHz
transmitler powet
Pune the
T105
transceiver to and aclyust
P1O8& Jor maximum
AfLel
into the load
(lO) Set the OPERATION switch to the receive mode,
and without changing the VFO or PRESELECTOR
te 4000)
a 1000) He beat notes Seb TE] te
Ti04 for
a n t a . k zl] ae " =! awe
sethinies, tune the RF sitnal ener alet
KHe and obtain
TTLEL f-
the mid-capacitance pom Adpust
mum aicia output as deseribed in step 2
(11) Set the PRESELECTOR at the lower edge of the
ell meter sement,
Fol and TC6
output mite the dummy load,
VEO} at 2.500 KHz, and acjust
far Maxwium transmitter power
(l2 i set the OPERATION swatch to the receive mocte,
TOMTCo = TC26
TC23 TC22 TC21
4 | i
te
ae ad \
Tcl TCITCs TC? TCé
000 KHz,
and without chanegme the VFO) or PRESELECTOR
tune the RF ta 300
Kite and obtain a LOOM He beat note. Adjust TC)
Sereines. sonal generator
for maximum aucio output as described in step 2.
(13) Repeat step 4) 10, 11, and 12 to peak out the coil
adjustments for
SC) meter Bands
(14)Set the BAND switch to 40, VFO at 7.000 KHz
and the PRESELECTOR to the lower edge of the
Vdjust TC! and TCY¥ for maxt-
pROREEr
1) meter SCTE L
mum transmitter Guiput ante the chanmy
loacl
Maximum power output. Adjust L33 for maximum
power output into the dummy load
(6iset the OPERATION switeh to the receive mode, and
set the VFO or PRESELECTOR
settings to the same
position as step 14, tune the RF signal generator to
7,000 KHz and obtain a 1000 Hz heat note: Adjust
TCL? for maximum audio output.
(17) Set the BAND switch to L600, VFO at 100 KHz and
the PRESELECTOR at 2 of the inner scale. Adjust
TC28 and TCO for
the dummy load,
maximum power output inte
(18) Turn
and
the OPERATION switch to the recerve mode,
leave the VFO and PRESELECTOR settings
unchanged. Apply the RF signal generator output
at 1.900 KHz to antenna terminal. Adjust TC29 for
Maximum S-meter reacdine.