Dangerous Voltages; Equipment Required - Yaesu FT-101E Instruction Manual

ALIGNMENT
WARNING
DANGEROUS VOLTAGES ARE PRESENT. USE
TRANSCEIVER
WITH COVERS
REMOVED.
CAUTION
Never operate the transceiver in the
transmit mode
without a matched antenna
or adequate
dummy load.
The power
amplifier tubes
and Fi
network
compo-
nents can
be damaged
if the transceiver
is operated without the proper
load termi-
nation.
GENERAL
The transceiver has been carefully alened and tested
at the factory and, with normal usage. should nor re
quire other than the usual attentian given to electronic
ECVMUIPMeEnE Service OF refracement m-a mapor component
may require subsequent realenment, but under no
ereumstance should realignment be attempted unless
the operation of the transeerver 1s fully understood,
the malfunction has been analized and definitely traced
fo misahernment.
AP UNIT
(PB-1315)™
SIDE TONE ADJ.
(VR,)
VOX ADL.
(VR)
iF UNIT —
(PB- 1183)
S.METER ADJ.—
(VR,}
# i
ALC ADU =|
(VR) /
BM ADA.
(VR, TC,)
MIX UNIT
CARRIER/MOD UNIT
(PB-1184)
ETC
EQUIPMENT REQUIRED
sond to 40) MHz
et
alyerage DOWer,
AP Signal Generator: Hewlett-Packard Model 200
AB, or equivalent.
range jrom 3 ta SO) Mis with a 100) KH» calth-
Paral
REG''CALIB UNIT
(PB-1314)
/
= —T.R ZERO ADJ.(VR,)
t —6V ADU(VR,}
* MARKER FREQ ADU.
(TC,)
—_RF UNIT
(PB-1181)
FIX/RF PROCESS UNIT
(PB-1534)