Transmitter Programming - CrimeStopper SP-100 Installation And Operating Instructions Manual

1. Turn Ignition ON.
2. Press the Program/Override Button 4 times. After a few second delay, the unit will chirp and flash the
lights 4 times.
3. Press button 1 on the remote control you wish to learn. You should get 2 light flashes indicating the unit
nd
is waiting for a 2
and flash the lights 3 times indicating its waiting for the 3
the unit will automatically exit code-learning mode, otherwise turn key off to exit programming mode.
Note 1: All transmitter codes must be learned at the time of programming. Any transmitters not present will
be dropped from system memory. This system will learn a total of 3 transmitters max.
TURN IGN ON
OFF
PRESS BUTTON #1
ON EACH REMOTE
REMOTE TRANSMITTER PROGRAMMING
code, then press button #1 of a second transmitter or transceiver, the unit will chirp
IGN
FLASH 2, 3, or 4 X's
rd
code and 4 times. If all 3 codes are learned,
PRESS PROGRAM
4 TIMES
7
WAIT FOR
4 FLASHES
IGN
OFF